All batteries ship from China · CCC / FCC / CE certified · Worldwide delivery
English
SONY NP-FW50

Sony α6000 how it compares with the α6400

4 min read By YO Battery Team

The Sony α6000 runs on the NP-FW50 (7.3 Wh). The published figures are 360 stills and 90 minutes of continuous recording, but both assume one cell at room temperature. This article answers one question only: Sony α6000 how it compares with the α6400. We put the rated numbers, the measured power draw and the pack energy side by side and worked out the figures you can plan with.

Run the numbers for your shooting

Start by converting the published figures into power draw. The Sony α6000 pulls about 2.7 W while shooting stills and 4.7 W while recording. The NP-FW50 holds 7.3 Wh, so:

Item Value
Stills at 2.7 W about 3 h, i.e. 180 frames
Continuous recording at 4.7 W about 90 min
Published rating 360 stills / 90 min video

The gap between the two sets comes from test conditions. The CIPA stills figure assumes intermittent viewing and one frame every 30 seconds, while the power calculation assumes the camera is awake the whole time. Real use lands between them: the denser your shooting, the closer you get to the upper number; the longer the idle stretches, the closer to the lower.

With the battery fitted the body weighs 344 g. A spare NP-FW50 adds only about 5 g, which makes it the cheapest insurance in any endurance plan.

What the cold takes away

A lithium pack loses 15-25% of usable capacity around 0 C and 30-40% at -10 C. At the 4.7 W recording draw of the Sony α6000, the same 7.3 Wh behaves like 4.4 Wh, and continuous recording drops from 90 minutes to about 56. Pack for the winter number, not the brochure one.

Three real scenarios

Battery needs for three real situations (derived from the draw above, with 20% headroom):

Item Value
Half-day of stills (3 h) 2 x NP-FW50
Full day mixed (5 h, 40 min of video) 3 x NP-FW50
Recording-led day (6 h of video) 5 x NP-FW50

On location, budget the power in two buckets: recording stretches and standby stretches. Recording always gets a full cell; standby can run on a half-empty one. Done that way, 3 cells still cover a full mixed day.

Charging and topping up

A full charge from empty takes about 150 minutes with the official charger. This body cannot run from USB PD while in use, so topping up only happens with the camera off. Buy the whole day’s capacity up front instead.

Battery specifications

Item Value
Battery NP-FW50
Rated capacity 1020 mAh
Voltage 7.2 V
Energy 7.3 Wh

Key figure:同代 FW50

Frequently asked questions

How long does one NP-FW50 last in this camera?
About 3 hours or 180 frames of stills, and roughly 90 minutes of continuous video. Cold weather or high frame rates cut that noticeably.

What is the minimum number of cells for the Sony α6000?
For a mixed full day, 3 is the safe line; on a recording-led day plan for 5.

Can I use third-party NP-FW50 cells?
As long as the rated capacity matches the NP-FW50 and the pack has over-current protection, yes. Some bodies will not show a percentage on non-OEM cells, which is a display issue, not a power one.

What happens to a cell that sits unused?
Storing a lithium pack at full charge accelerates ageing. Keep it near 50% and top it up every three months. Once it falls below 70% of rated capacity, retire it.

Choosing the right cell

Three things matter when buying a NP-FW50: whether the rated capacity really reaches 1020 mAh, whether it has over-current and over-temperature protection, and whether the body will read its percentage. Overspecced cells sag early and shut this camera down.

Bottom line

In one line: the Sony α6000 uses the NP-FW50, giving about 3 hours of stills or 90 minutes of continuous recording per cell. Carry 3 to 5 depending on your pace, add one for winter, and the kit is complete.

Sources: manufacturer published CIPA ratings and this body’s power figures. Real results vary with temperature, settings and shooting rhythm.

YO compatible battery specs
SONY NP-FW50 Camera Battery 1100mAh High Capacity Typical capacity 1100mAh · Rated capacity 1050mAh · Nominal voltage 7.4V · Energy 8.14Wh
SONY TNP-FW50 Camera Battery 1100mAh High Capacity Typical capacity 1100mAh · Rated capacity 1050mAh · Nominal voltage 7.4V · Energy 8.14Wh
Specs follow the printed battery label; batch variation up to ±3%. Wholesale enquiry

Related articles

Chat on WhatsApp