All batteries ship from China · CCC / FCC / CE certified · Worldwide delivery
English
Nikon EN-EL25

Nikon Z50 II energy gap against EN-EL15 bodies

4 min read By YO Battery Team

The Nikon Z50 II runs on the EN-EL25 (8.5 Wh). The published figures are 250 stills and 95 minutes of continuous recording, but both assume one cell at room temperature. This article answers one question only: Nikon Z50 II energy gap against EN-EL15 bodies. We put the rated numbers, the measured power draw and the pack energy side by side and worked out the figures you can plan with.

Run the numbers for your shooting

Start by converting the published figures into power draw. The Nikon Z50 II pulls about 4.1 W while shooting stills and 5.6 W while recording. The EN-EL25 holds 8.5 Wh, so:

Item Value
Stills at 4.1 W about 2.1 h, i.e. 125 frames
Continuous recording at 5.6 W about 95 min
Published rating 250 stills / 95 min video

The gap between the two sets comes from test conditions. The CIPA stills figure assumes intermittent viewing and one frame every 30 seconds, while the power calculation assumes the camera is awake the whole time. Real use lands between them: the denser your shooting, the closer you get to the upper number; the longer the idle stretches, the closer to the lower.

With the battery fitted the body weighs 550 g. A spare EN-EL25 adds only about 5 g, which makes it the cheapest insurance in any endurance plan.

What the cold takes away

A lithium pack loses 15-25% of usable capacity around 0 C and 30-40% at -10 C. At the 5.6 W recording draw of the Nikon Z50 II, the same 8.5 Wh behaves like 5.1 Wh, and continuous recording drops from 95 minutes to about 55. Pack for the winter number, not the brochure one.

Three real scenarios

Battery needs for three real situations (derived from the draw above, with 20% headroom):

Item Value
Half-day of stills (3 h) 2 x EN-EL25
Full day mixed (5 h, 40 min of video) 4 x EN-EL25
Recording-led day (6 h of video) 5 x EN-EL25

On location, budget the power in two buckets: recording stretches and standby stretches. Recording always gets a full cell; standby can run on a half-empty one. Done that way, 4 cells still cover a full mixed day.

Charging and topping up

A full charge from empty takes about 120 minutes with the official charger. The body supports USB PD, so a power bank can top it up between takes. When it is running off external power the load is shared and you get roughly 30% more shooting time.

Battery specifications

Item Value
Battery EN-EL25
Rated capacity 1120 mAh
Voltage 7.6 V
Energy 8.5 Wh

Key figure:8.5Wh vs 16Wh

Frequently asked questions

How long does one EN-EL25 last in this camera?
About 2.1 hours or 125 frames of stills, and roughly 95 minutes of continuous video. Cold weather or high frame rates cut that noticeably.

What is the minimum number of cells for the Nikon Z50 II?
For a mixed full day, 4 is the safe line; on a recording-led day plan for 5.

Can I use third-party EN-EL25 cells?
As long as the rated capacity matches the EN-EL25 and the pack has over-current protection, yes. Some bodies will not show a percentage on non-OEM cells, which is a display issue, not a power one.

What happens to a cell that sits unused?
Storing a lithium pack at full charge accelerates ageing. Keep it near 50% and top it up every three months. Once it falls below 70% of rated capacity, retire it.

Choosing the right cell

Three things matter when buying a EN-EL25: whether the rated capacity really reaches 1120 mAh, whether it has over-current and over-temperature protection, and whether the body will read its percentage. Overspecced cells sag early and shut this camera down.

Bottom line

In one line: the Nikon Z50 II uses the EN-EL25, giving about 2.1 hours of stills or 95 minutes of continuous recording per cell. Carry 4 to 5 depending on your pace, add one for winter, and the kit is complete.

Sources: manufacturer published CIPA ratings and this body’s power figures. Real results vary with temperature, settings and shooting rhythm.

YO compatible battery specs
NIKON EN-EL25 Camera Battery 1350mAh High Capacity Typical capacity 1350mAh · Rated capacity 1280mAh · Nominal voltage 7.6V · Energy 10.26Wh
Specs follow the printed battery label; batch variation up to ±3%. Wholesale enquiry

Related articles

Chat on WhatsApp