Posted on — Leave a comment

NP-BX1 Compatibility Chart: 22 Bodies and the Models That Do Not Fit

The NP-BX1 covers 22 bodies, from the RX100 to the FDR-X1000V; the most common buying mistake is not capacity but boundary cases such as NP-BN / NP-BN1. The table below lists every compatible body by series, followed by the models that take a different cell. Always trust the marking on the camera or in the battery compartment: similar-looking packs are not necessarily interchangeable, and NP-BX1 should still be checked against the contacts and firmware of your body.

By CIPA standard the RX100 VII delivers about 250 shots per charge (220–330 / ZV-1 4K 45–60 min). Real-world figures fall with viewfinder use, bursts, flash and low temperature, so budgeting around 70% of the rating is safer.

Full compatibility list

All 22 bodies below accept the NP-BX1 or a cell from the same family, grouped by series. “Compatible” means the compartment and contacts match; it does not guarantee that older bodies can exploit the full capacity of a high-capacity pack.

Body Body Body Body
RX100 RX100 II RX100 III RX100 IV
RX100 V RX100 VI RX100 VII ZV-1
ZV-1 II ZV-1F RX1 RX1R
RX1R II HX90 HX90V HX80
HX60 HX50 WX500 WX350
HDR-AS50 FDR-X1000V

Which models do not fit

This is where search results most often mislead. Packs with similar names and near-identical shells frequently belong to entirely different systems, and forcing one in can damage the compartment.

Item Value
NP-BX1 NP-BX1
NP-BX1 Sony NP-BX1
np-bx1 1090 mAh / 4.04 Wh
RX100 VII 250 / 220–330 / ZV-1 4K 45–60 min
NP-BN / NP-BN1 NP-BX1
NP-BX1 1090 mAh / 4.04 Wh

How to check before ordering

The reliable check is the model printed on the bottom of the body or inside the battery compartment, matched against this list. On a used camera, also confirm that a previous owner has not swapped the battery door.

To pick by model, start with the specifications and stock status on Sony NP-BX1 1090mAh, then browse the full article set in NP-BX1; if your body belongs to a neighbouring system, NP-F960 has the side-by-side explanation.

YO compatible battery specs
SONY NP-BX1 Camera Battery 1090mAh High Capacity Typical capacity 1090mAh · Rated capacity 1060mAh · Nominal voltage 3.7V · Energy 4.04Wh
Specs follow the printed battery label; batch variation up to ±3%. Wholesale enquiry

FAQ

How many bodies take the NP-BX1?

Our list contains 22 bodies, from the RX100 to the FDR-X1000V. It is grouped by series, but still check the body marking, since a later generation in the same line can switch cells.

Is the NP-BX1 interchangeable with neighbouring models?

NP-BX1 shares one shell and contact layout, so those cells fit each other. However, NP-BN / NP-BN1, and those bodies need their own cell — never judge by shape alone.

Will every body on the list benefit from higher capacity?

All of them run normally, but older bodies set their cutoff and fuel gauge to the original specification, so extra shots do not scale linearly and the percentage may read conservatively.

How do I confirm which cell to buy?

Read the model on the bottom plate or inside the battery compartment and match it against this list. If the marking includes a suffix or a “for use with” note, follow the manual rather than the capacity figure.

Leave a Reply

Your email address will not be published. Required fields are marked *