Compare watt-hours before milliamp-hours: our LP-E6 compatible cell is 2600mAh / 18.72Wh, while the original LP-E6NH is 2130mAh / 16Wh. Milliamp-hours describe charge, not energy, so they cannot be compared across voltage platforms. Watt-hours (voltage x capacity) are the honest figure. Where a label states both a typical and a minimum rating, use the minimum for conservative runtime estimates.
Key specifications and limits: 8K / 30 fps → LP-E6P / LC-E6 150 min. Actual figures vary with resolution, frame rate, screen brightness and ambient temperature, so plan spares around the shortest figure in the table.
Two further versions are available in this system: LP-E6+ and LP-E6P, both rated 2600mAh. The EOS R5 Mark II identifies the cell and throttles 8K recording and 30fps bursts without the high-discharge LP-E6P; for ordinary shooting the LP-E6NH specification is sufficient.
Original vs our cell, item by item
The table puts the original rating and our compatible cell on the same basis. Price is the listed retail figure; check the product page for current terms. Where a minimum rating is printed, that figure is the better basis for conservative estimates.
| Item | Original | Our compatible cell |
|---|---|---|
| LP-E6 | 2130 mAh | 2600 mAh |
| Wh | 16 Wh | 18.72 Wh |
| mAh (min) | — | 2400 mAh |
| CNY | — | ¥111.6 |
Balancing capacity, price and warranty
Higher capacity does not double your shots: the body cutoff voltage and its fuel-gauge algorithm both shape the reading. For a spare cell, price, cycle life and warranty often matter more than the peak number.
| Item | Value |
|---|---|
| LP-E6 | LP-E6 / E6N / E6NH / E6P |
| LP-E6NH | 2130 mAh / 16 Wh |
| lp-e6nh | 2600 mAh / 18.72 Wh |
| LP-E6 | 8K / 30 fps → LP-E6P / LC-E6 150 min |
| R5 II 8K / 30 fps → LP-E6P | LP-E6 / E6N / E6NH / E6P |
| LP-E6 / E6N / E6NH / E6P | 2600 mAh / 18.72 Wh |
Choosing a kit by shooting load
For light use, one original plus one spare is enough. For a full day of travel or video work, carry two or more and rotate them through a dual-bay charger.
To pick by model, start with the specifications and stock status on Canon LP-E6 2600mAh, then browse the full article set in LP-E6; if your body belongs to a neighbouring system, canon-lp-e17 has the side-by-side explanation.
FAQ
Is 2600mAh an inflated rating?
Our LP-E6 compatible cell is specified at 2600mAh / 18.72Wh. The label also states a minimum of 2400mAh. while the original LP-E6NH is 2130mAh / 16Wh. Compare the Wh figures rather than mAh alone.
Should I look at mAh or Wh?
Wh. Milliamp-hours only become energy once multiplied by voltage, so comparing mAh across different voltage platforms is misleading. 18.72Wh is the like-for-like baseline for this pack.
Can a higher-capacity cell damage the camera?
No. As long as the shell, contacts and protection circuit match the system, capacity only affects runtime. The one caveat is that older bodies may report charge level inaccurately.
Should I buy one cell or two?
For a full day outside or video work, carry two or more and rotate them through a dual dock. For indoor or short sessions, one original plus one spare is enough. Budget conservatively against the EOS R5 II baseline.